Opel Omega

since 1993-1999 release

Repair and operation of the car


Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
- 10. Main transfer, half shafts
   10.1. Technical characteristics
   10.2. Main transfer
   10.3. Damping plugs of the main transfer
   10.4. Laying of a back cover of the main transfer
   10.5. Epiploon of the leading gear wheel of the main transfer
   10.6. Epiploons of bearings of half shafts
   10.7. Half shaft
   10.8. Boots of a half shaft and external CV JOINT
   10.9. Driveshaft
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment


785173a6
https://kikma.site

10.9. Driveshaft

 Removal

PERFORMANCE ORDER
1. Remove heat-shielding screens of catalytic converters.
2. Turn off the bolts (are specified by shooters) fixing the driveshaft to a transmission flange.
3. Turn off the bolts (are specified by shooters) fixing the driveshaft to a differential flange.
3. Turn off fixing bolts of an intermediate support (are specified by shooters) and remove the driveshaft.

Installation

Installation is carried out to the sequences, the return to removal.

CENTRAL BEARING OF THE DRIVESHAFT

Replacement
PERFORMANCE ORDER
1. Remove the driveshaft.
2. Mark an arrangement of sections of the driveshaft and disconnect forward section.
3. Remove a cover, a lock ring and a washer.
4. Remove a bearing casing from a fixing arm.
5. Squeeze out the old bearing and a napressuyta new.
6. Assembly is carried out upside-down. For the correct installation of forward section of the driveshaft serves directing vents (it is specified by an arrow).

FLEXIBLE CONNECTING DISKS OF THE DRIVESHAFT

Replacement
PERFORMANCE ORDER
1. Disconnect a half shaft from a flange of the transmission or differential.
2. Take a shaft aside and remove the corresponding disk, having picked up it the screw-driver if it is necessary.
3. Installation is carried out to the sequences, the return to removal.