Opel Omega
+ 1. Maintenance instruction
- 2. Maintenance
- 2.1. Cars with petrol engines
2.1.1. Technical characteristics
2.1.2. Current maintenance
+ 2.1.3. Through 8000 km of a run or each 6 months
+ 2.1.4. Through 16 000 km of a run or each 12 months
+ 2.1.5. Through 32 000 km of a run or each 2 years
+ 2.1.6. Through 64 000 km of a run or each 4 years
+ 2.1.7. Through 112 000 km of a run or each 7 years
+ 2.1.8. Each 2 years irrespective of a run
+ 2.2. Cars with diesel engines
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
Type of a motive compartment of models with the DOHC engine of 2,0 l
1. Cap of a jellied mouth of engine oil
2. Casing of the air filter
3. Top fastening of a rack of a forward suspension bracket
4. Tank of brake fluid
5. Relay block
6. Broad tank
7. Accumulator
8. The block of the burned-through crossing points |
9. Pump of system of the hydraulic booster of steering
10. The probe for check of level of engine oil
11. Oil filter
12. Generator
13. Air stream sensor
14. Casing of a butterfly valve
15. Tank of system of the hydraulic booster of steering |
Type of a motive compartment of models with the 2,5 l engine (the 3,0 l engine is similar)
1. Cap of a jellied mouth of engine oil
2. Tank of system of the hydraulic booster of steering
3. Top fastening of a rack of a forward suspension bracket
4. Relay block
5. The block of the burned-through crossing points
6. The probe for check of level of engine oil
7. Accumulator |
8. Air chamber
9. Air stream sensor
10. Air filter
11. Broad tank of the cooling system
12. Tank of brake fluid
13. Valve of recirculation of exhaust gases
14. Inlet collector
15. Valve of adjustment of speed of idling |
The bottom view of a motive compartment of models with the DOHC engine of 2,0 l (other models are similar)
1. Reception pipe of the exhaust system
2. Oil filter
3. Cap of a drain opening of engine oil
4. Conditioner compressor
5. Lower lever of a suspension bracket
6. External steering draft |
7. Steering bipod
8. Central steering draft
9. Steering bipod
10. External steering draft
11. Mechanical transmission
12. Oxygen sensor
13. Cross-piece of fastening of the transmission |
In this manual the term "maintenance" belongs to set of the performed works, but not to the concrete procedure.
If from the moment of acquisition of the new car in accuracy to observe a maintenance order, to carry out frequent inspections of level of the liquids and details subject to the increased wear what it is insistently reminded in the Management of, then at the engine high operational qualities will remain and the volume of additional works will be minimized.
However if to carry out maintenance irregularly, then operation of the engine, most likely, will be unsatisfactory. Especially it concerns the engine of the car acquired not novoy which was not exposed to regular checks. In such cases besides periodic maintenance it is necessary to perform additional adjustment works.
Any kind of works on maintenance or search of the reason of abnormal operation of the engine should be begun with check of a compression in cylinders. Check of a compression in cylinders gives valuable information of rather general condition of many details of the internal device of the engine which can be used as fundamental both for the current maintenance, and for repair procedures. If, for example, a compression such is that strong wear of the engine is obvious, then routine maintenance will not lead to restoration of normal operational qualities and all works come down to an excessive waste of time and money.
The list of works which performance often leads to recovery of normal operation of the engine is given below.
Primary checks:
– clear, examine and check the accumulator;
– check the level of oil and cooling liquid;
– check a state and a tension of a driving belt;
– replace spark plugs;
– check the air filter and replace it if it is necessary;
– check the fuel filter;
– check a condition of all hoses and examine them on leak existence.
If the operations stated above were not effective, execute secondary checks – all operations which are listed above plus:
– check system of recharge of the accumulator;
– check system of ignition;
– check a power supply system. |
|
