Opel Omega

since 1993-1999 release

Repair and operation of the car

Opel Omega
+ 1. Maintenance instruction
- 2. Maintenance
   - 2.1. Cars with petrol engines
      2.1.1. Technical characteristics
      2.1.2. Current maintenance
      + 2.1.3. Through 8000 km of a run or each 6 months
      + 2.1.4. Through 16 000 km of a run or each 12 months
      + 2.1.5. Through 32 000 km of a run or each 2 years
      + 2.1.6. Through 64 000 km of a run or each 4 years
      - 2.1.7. Through 112 000 km of a run or each 7 years
         2.1.7.1. Liquid of the automatic transmission
      + 2.1.8. Each 2 years irrespective of a run
   + 2.2. Cars with diesel engines
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

На spetsmedpribor.net аккомодотренер.

2.1.7. Through 112 000 km of a run or each 7 years

2.1.7.1. Liquid of the automatic transmission

GENERAL INFORMATION

Liquid level in automatic transmission should be checked and supported systematically. Insufficient level of liquid involves pro-slipping of details of transmission and decrease in road performance of the car. At excess level there is a foaming which is followed by loss of liquid and an exit of transmission out of operation.

It is necessary to check liquid level in automatic transmission after warming up of liquid up to the working temperature. Liquid is considered the heated-up ambassador of a trip in the usual mode on distance of 16 km (or 24 km at cold weather) at a temperature of liquid from 70 ° to 80 °C.

Check

PERFORMANCE ORDER

1. Install the car on the flat horizontal platform, tighten the emergency brake, start the engine and transfer to an operating mode idling.
2. Press a pedal of a brake and translate the selector lever from situation P through all range of transfers to extreme situation and again return to situation P.
3. Get the control probe from a tube (the engine continues to idle) both check the level of liquid and remember. Wipe the probe with pure rags, again insert the probe into a tube against the stop. Again get the probe and check liquid level.
4. If level was checked on cold liquid, then it has to be between tags of Cold or Cool if the level checked on hot liquid has to be between Hot tags. If level is near the lower tags, then add liquid of the recommended brand through a funnel. Add only necessary amount of liquid, without exceeding admissible level. To finish level from the lower mark to top about about 0,5 l of liquid are necessary (if liquid hot). Add liquid in very small portions, periodically checking level.
5. When checking level, check also a condition of liquid. If liquid of black or dark brown color or extends a burned smell, then it needs to be replaced. At a doubtful state buy a little new transmission liquid and compare with fulfilled on color and a smell.