Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   + 3.1. SOHC engines of 2,0 liters
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   - 3.4. Partition of all petrol engines
      3.4.1. Technical characteristics
      3.4.2. Check of a compression
      + 3.4.3. Engine partition
      3.4.4. Auxiliary elements of the engine
      + 3.4.5. Engine
      3.4.6. Engine partition
      3.4.7. Head of cylinders and valves
      3.4.8. Pistons and rods
      3.4.9. Bent shaft
      3.4.10. Block of cylinders
      3.4.11. Radical bearings and bearings of rods
      3.4.12. Piston rings
      3.4.13. The first start of the engine after a partition
   + 3.5. 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment


785173a6

3.4.12. Piston rings

GENERAL INFORMATION

Correct arrangement of trailer gaps of piston rings

I. Compression rings

II. Side elements of an oil scraper ring

Installation

PERFORMANCE ORDER
1. Before installation it is necessary to check trailer and side gaps of piston rings.
2. Install the top compression ring in the cylinder by means of the piston.
3. Measure a trailer gap of a ring by means of the probe. If a gap too small, replace piston rings or grind the ends of the available rings a small file. Be careful, piston rings sharp and easily break.
4. Carry out the similar procedure with all rings.
5. After check and adjustment of a trailer gap of a ring it is possible to install on pistons.
6. The oil scraper ring is established by the first. At first establish a broad ring in a flute, then establish the lower and top oil scraper rings.
7. After installation of all elements of an oil scraper ring check that the top and lower rings rotated freely.
8. Establish the second compression ring by a mark up.
9. Then establish the top compression ring.
10. By means of the probe measure gaps between rings and their flutes.