Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
- 5. Fuel, exhaust systems
   + 5.1. Petrol engines
   - 5.2. 2,0 liters diesel engine
      5.2.1. Technical characteristics
      5.2.2. Air filter and air inlet channels
      5.2.3. Accelerator pedal
      5.2.4. Filling and pumping of fuel system
      5.2.5. Fuel level sensor
      5.2.6. Fuel tank
      5.2.7. Check and adjustment of the maximum turns
      5.2.8. Electric knots of system of injection
      5.2.9. Fuel pump of high pressure
      5.2.10. Fuel injection moment
      5.2.11. Fuel nozzles
      5.2.12. Turbocharger
      5.2.13. Inlet collector
      5.2.14. Final collector
   + 5.3. Diesel V6 engine of 2,5 liters
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment


785173a6

5.2.7. Check and adjustment of the maximum turns

GENERAL INFORMATION

The maximum turns of the engine are established by the ECU block and cannot be adjusted.

Start of the cold engine

Turns of idling and the moment of injection of fuel are defined by the ECU block.

Adjustment

PERFORMANCE ORDER
1. Warm up the engine up to the working temperature, check turns of idling and cool the engine.
2. On the cold engine check a gap between the screw of adjustment and a control lever of the fuel pump. At a temperature of cooling liquid of 20 °C the gap has to be ranging from 0,8 to 1,1 mm.
3. For adjustment of a gap weaken a lock-nut and, rotating the adjusting screw, establish the required gap then establish a lock-nut.
4. Start the engine and check idling turns. If turns of idling differ from demanded, weaken a lock-nut and, rotating the adjusting screw, establish the required turns then tighten a lock-nut.
5. Warm up the engine and check idling turns. In the course of warming up of the engine the gap between the adjusting screw and a control lever of the fuel pump has to decrease gradually before full contact of the screw with the lever. Otherwise there is a damage to system of cold start of the engine, and it is necessary to make repair at a maintenance stage.