Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
+ 3.1. SOHC engines of 2,0 liters
- 3.2. DOHC engines of 2,0 liters
3.2.1. Technical characteristics
3.2.2. Check of a compression
3.2.3. Top Dead Point (TDP) of the N1 piston
3.2.4. Cover of camshafts
3.2.5. Pulley of a bent shaft
3.2.6. Covers of a gas-distributing belt
3.2.7. Gas-distributing belt
3.2.8. Natyazhitel of a belt, asterisks and intermediate pulleys
3.2.9. Epiploons of camshafts
3.2.10. Camshafts and pushers
3.2.11. Head of cylinders
3.2.12. Oil pallet
3.2.13. Oil pump
3.2.14. System of an equilibration of a bent shaft (engines since 1998)
3.2.15. Flywheel
3.2.16. Epiploons of a bent shaft
3.2.17. Fastenings of the engine and transmission
+ 3.3. 2,5 and 3,0 liters engines
+ 3.4. Partition of all petrol engines
+ 3.5. 2,0 liters diesel engine
+ 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
Removal
MECHANICAL TRANSMISSION
| PERFORMANCE ORDER |
| 1. Remove the transmission and coupling. |
|
|
2. Stop a flywheel and note its correct adjusting arrangement. |
| 3. Unscrew bolts and remove a flywheel. |
|
AUTOMATIC TRANSMISSION
| PERFORMANCE ORDER |
| 1. Remove the transmission. |
| 2. Stop a drive plate and weaken its bolts. |
| 3. Completely unscrew bolts and remove a drive plate. |
|
Check
| PERFORMANCE ORDER |
| Check a flywheel for existence of wear and damages. At detection of those, address the expert. |
|
Installation
MECHANICAL TRANSMISSION
| PERFORMANCE ORDER |
| 1. Clean the joined surfaces of a flywheel and a bent shaft. Clean carvings of bolts. |
|
|
| 2. Establish a flywheel, insert and tighten bolts (the drawing at the left), tighten bolts in addition on a necessary corner (the drawing on the right) (see subsection 3.2.1) |
| 3. Establish coupling and the transmission. |
|
AUTOMATIC TRANSMISSION
| PERFORMANCE ORDER |
| 1. Clean the joined surfaces of a drive plate and a bent shaft. Clean carvings of bolts. |
| 2. Establish a drive plate and tighten bolts. |
|
|
|
