Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   + 3.1. SOHC engines of 2,0 liters
   - 3.2. DOHC engines of 2,0 liters
      3.2.1. Technical characteristics
      3.2.2. Check of a compression
      3.2.3. Top Dead Point (TDP) of the N1 piston
      3.2.4. Cover of camshafts
      3.2.5. Pulley of a bent shaft
      3.2.6. Covers of a gas-distributing belt
      3.2.7. Gas-distributing belt
      3.2.8. Natyazhitel of a belt, asterisks and intermediate pulleys
      3.2.9. Epiploons of camshafts
      3.2.10. Camshafts and pushers
      3.2.11. Head of cylinders
      3.2.12. Oil pallet
      3.2.13. Oil pump
      3.2.14. System of an equilibration of a bent shaft (engines since 1998)
      3.2.15. Flywheel
      3.2.16. Epiploons of a bent shaft
      3.2.17. Fastenings of the engine and transmission
   + 3.3. 2,5 and 3,0 liters engines
   + 3.4. Partition of all petrol engines
   + 3.5. 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
785173a6



3.2.4. Cover of camshafts

Removal

PERFORMANCE ORDER
1. Disconnect ventilating hoses from a cover of camshafts.
2. Unscrew bolts and uncover spark plugs (the drawing at the left), disconnect wires from candles (the drawing on the right).
3. Weaken a nut and uncover the holder a plait wires in the top part of a gas-distributing belt.
4. Disconnect a wire from the sensor of the camshaft and from a cover of camshafts.
5. Unscrew bolts of a cover of camshafts.
6. Uncover also laying, if necessary replace laying.

Installation

PERFORMANCE ORDER
1. Carefully examine and clean the joined surfaces of a cover and a head of cylinders. Establish laying.
2. Apply N15 03 295 sealant on a surface of a head of cylinders around covers of forward bearings of camshafts and in semicircular cuts in a back part of a head.
3. Establish a cover, insert and tighten bolts.
4. Establish the remained details.