Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
+ 3.1. SOHC engines of 2,0 liters
- 3.2. DOHC engines of 2,0 liters
3.2.1. Technical characteristics
3.2.2. Check of a compression
3.2.3. Top Dead Point (TDP) of the N1 piston
3.2.4. Cover of camshafts
3.2.5. Pulley of a bent shaft
3.2.6. Covers of a gas-distributing belt
3.2.7. Gas-distributing belt
3.2.8. Natyazhitel of a belt, asterisks and intermediate pulleys
3.2.9. Epiploons of camshafts
3.2.10. Camshafts and pushers
3.2.11. Head of cylinders
3.2.12. Oil pallet
3.2.13. Oil pump
3.2.14. System of an equilibration of a bent shaft (engines since 1998)
3.2.15. Flywheel
3.2.16. Epiploons of a bent shaft
3.2.17. Fastenings of the engine and transmission
+ 3.3. 2,5 and 3,0 liters engines
+ 3.4. Partition of all petrol engines
+ 3.5. 2,0 liters diesel engine
+ 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
Replacement
FORWARD EPIPLOON OF THE BENT SHAFT
| PERFORMANCE ORDER |
| 1. Remove an asterisk of a bent shaft |
|
|
2. Drill two holes in an epiploon, screw in in them screws and take an epiploon. |
| 3. Carefully clean an epiploon groove. |
| 4. Oil a new epiploon and hammer it on the place. |
|
BACK EPIPLOON OF THE BENT SHAFT
| PERFORMANCE ORDER |
| 1. Remove a flywheel. |
| 2. Drill two holes in an epiploon, screw in in them screws and take an epiploon. Establish a new epiploon. |
| 3. Establish a flywheel into place. |
|
|
|
