Opel Omega

since 1993-1999 release

Repair and operation of the car

Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
- 11. Brake system
   11.1. Technical characteristics
   11.2. Brake overlays of forward brakes
   11.3. Brake overlays of back brakes
   11.4. Support of a forward brake
   11.5. Support of a back brake
   11.6. Brake disk
   11.7. Brake shoes of the emergency brake
   11.8. Rope of the emergency brake
   11.9. Lever of the emergency brake
   11:10. Main brake cylinder
   11:11. Tank of brake fluid and sensor of level of liquid
   11:12. Pumping of the brake system
   11:13. Hydraulic tubes and hoses
   11:14. Vacuum hose and valve of the vacuum amplifier of brakes
   11:15. Vacuum amplifier
   11:16. Brake pedal
   11:17. System of anti-blocking of brakes / protivobuksovochny system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

11.2. Brake overlays of forward brakes

Removal

PERFORMANCE ORDER

1. Check thickness of slips through an opening in a brake support.
	2. If slips need to be replaced, remove the wear sensor.
	3. Remove a fixing clip and remove a brake hose from a fixing arm.
Models till 1998 of release with the 4-cylinder engine
	4. Remove a big spring clip.
	5. Remove caps.
	6. Turn off and remove bolts of fingers of a support.
	7. Remove a support. Remove an external brake slip from a fixing arm of a support.
	8. Remove an internal brake slip from the support piston.
Models with the 4-cylinder engine since 1998 of release and all models with the 6-cylinder engine

9. Turn off and remove a bolt of the lower finger of a support.
	10. Lift a support.

11. Remove internal and external brake slips.

Survey

PERFORMANCE ORDER

	1. Measure thickness of brake slips. If any of brake slips demands replacement, it is necessary to replace all four brake slips on both wheels.
	2. Lower the piston deep into of a support by means of a clamp.
	3. Grease with high-temperature lubricant a reverse side of slips.
	4. Grease with high-temperature lubricant adjacent areas on a fixing arm of a support.

Installation

PERFORMANCE ORDER

Installation is carried out to the sequences, the return to removal. On models with the 4-cylinder engine of release till 1998 establish a fixing spring so that its ends got to openings on a support.