Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
- 11. Brake system
11.1. Technical characteristics
11.2. Brake overlays of forward brakes
11.3. Brake overlays of back brakes
11.4. Support of a forward brake
11.5. Support of a back brake
11.6. Brake disk
11.7. Brake shoes of the emergency brake
11.8. Rope of the emergency brake
11.9. Lever of the emergency brake
11:10. Main brake cylinder
11:11. Tank of brake fluid and sensor of level of liquid
11:12. Pumping of the brake system
11:13. Hydraulic tubes and hoses
11:14. Vacuum hose and valve of the vacuum amplifier of brakes
11:15. Vacuum amplifier
11:16. Brake pedal
11:17. System of anti-blocking of brakes / protivobuksovochny system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
Survey
| PERFORMANCE ORDER |
| Examine brake overlays for existence of wear and measure their thickness by means of a ruler. If any of brake slips demands replacement, it is necessary to replace all four brake slips on both wheels together with antinoise slips. |
|
Removal
| PERFORMANCE ORDER |
|
1. Beat out the top fixing pin of antinoise springs. |
|
2. Remove an antinoise spring. |
|
3. Beat out the lower pin. |
|
|
| 4. By means of flat-nose pliers or the special tool part brake slips a little in the parties. |
|
5. Remove brake slips. |
|
Installation
Installation is carried out to the sequences, the return to removal.
Check
| PERFORMANCE ORDER |
|
1. Lower pistons deep into of a support. |
|
2. Check that cuts on pistons were turned down approximately at an angle in 23 ° in a horizontal. |
|
3. Grease the return surface of slips with high-temperature lubricant. |
|
4. Establish into place fixing pins. |
|
|
|
