Opel Omega

since 1993-1999 release

Repair and operation of the car

Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
- 11. Brake system
   11.1. Technical characteristics
   11.2. Brake overlays of forward brakes
   11.3. Brake overlays of back brakes
   11.4. Support of a forward brake
   11.5. Support of a back brake
   11.6. Brake disk
   11.7. Brake shoes of the emergency brake
   11.8. Rope of the emergency brake
   11.9. Lever of the emergency brake
   11:10. Main brake cylinder
   11:11. Tank of brake fluid and sensor of level of liquid
   11:12. Pumping of the brake system
   11:13. Hydraulic tubes and hoses
   11:14. Vacuum hose and valve of the vacuum amplifier of brakes
   11:15. Vacuum amplifier
   11:16. Brake pedal
   11:17. System of anti-blocking of brakes / protivobuksovochny system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

11.4. Support of a forward brake

Removal

PERFORMANCE ORDER

1. Remove a big fixing clip from a support if it is necessary.

2. Turn off bolts of fingers of a support.
	3. Remove a support from a fixing arm.
4. Press a brake hose, turn off a bolt of connection and disconnect a hose from a support.
	5. Turn off two fixing bolts.
	6. Remove a fixing arm of a support.

Repair

PERFORMANCE ORDER

	1. Clear a support, unbend uvulas (are specified by shooters) and remove a protective plate from the piston if it is necessary.
2. Remove the piston and consolidation.
	3. Remove hydraulic consolidation of the piston, trying not to scratch cylinder walls (by means of the blunt nonmetallic tool).
4. Squeeze out plugs from fixing openings of a support.
5. Wash out all elements in pure brake fluid and replace the worn-out or damaged elements.

Assembly

PERFORMANCE ORDER

1. Assembly of elements of a support is carried out upside-down.
	2. Grease walls of the cylinder, consolidation and the piston with brake fluid before installation. On models with the 4-cylinder engine till 1998 of release turn the piston so that the acting part of the piston was located horizontally in relation to a support.

Installation

Installation is carried out to the sequences, the return to removal.