Opel Omega

since 1993-1999 release

Repair and operation of the car

Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   - 3.1. SOHC engines of 2,0 liters
      3.1.1. Technical characteristics
      3.1.2. Check of a compression
      3.1.3. Top Dead Point (TDP) of the N1 piston
      3.1.4. Camshaft cover
      3.1.5. Pulley of a bent shaft
      3.1.6. Covers of a gas-distributing belt
      3.1.7. Gas-distributing belt
      3.1.8. Natyazhitel of a gas-distributing belt and asterisk
      3.1.9. Camshaft epiploon
      3.1.10. Casing of the camshaft and camshaft
      3.1.11. Pushers and hydraulic elevators
      3.1.12. Head of cylinders
      3.1.13. Oil pallet
      3.1.14. Oil pump
      3.1.15. Flywheel
      3.1.16. Epiploons of a bent shaft
      3.1.17. Fastenings of the engine and transmission
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   + 3.4. Partition of all petrol engines
   + 3.5. 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

3.1.11. Pushers and hydraulic elevators

WORK WITH USE OF THE N KM-565 TOOL

PERFORMANCE ORDER

1. Uncover the camshaft.

2. Turn a bent shaft so that the cam of the camshaft of that pusher which you are going to remove was directed strictly up. Unscrew a spark plug from the corresponding cylinder.

3. Fix the special tool on a casing of the camshaft and remove a pusher, the hydraulic elevator and a persistent lining from the top part of the valve.

4. Oil the removed details and establish on the places.

WORK WITHOUT SPECIAL TOOL

Removal

PERFORMANCE ORDER

1. Remove a camshaft casing.
2. Prepare eight numbered boxes.
	3. Remove pushers from valves.
	4. Remove hydraulic elevators.
	5. Remove persistent linings.
6. Put details of each of valves in the corresponding box.

Check

PERFORMANCE ORDER

Examine the removed details on existence of wear tracks and damages. If necessary replace the worn-out and damaged details.

Installation

PERFORMANCE ORDER

1. Grease elevators and openings of elevators in a head of cylinders with oil.

2. Establish persistent linings.

3. Oil pushers and establish them on the places.