Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
- 3.1. SOHC engines of 2,0 liters
3.1.1. Technical characteristics
3.1.2. Check of a compression
3.1.3. Top Dead Point (TDP) of the N1 piston
3.1.4. Camshaft cover
3.1.5. Pulley of a bent shaft
3.1.6. Covers of a gas-distributing belt
3.1.7. Gas-distributing belt
3.1.8. Natyazhitel of a gas-distributing belt and asterisk
3.1.9. Camshaft epiploon
3.1.10. Casing of the camshaft and camshaft
3.1.11. Pushers and hydraulic elevators
3.1.12. Head of cylinders
3.1.13. Oil pallet
3.1.14. Oil pump
3.1.15. Flywheel
3.1.16. Epiploons of a bent shaft
3.1.17. Fastenings of the engine and transmission
+ 3.2. DOHC engines of 2,0 liters
+ 3.3. 2,5 and 3,0 liters engines
+ 3.4. Partition of all petrol engines
+ 3.5. 2,0 liters diesel engine
+ 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
Replacement
FORWARD EPIPLOON OF THE BENT SHAFT
| PERFORMANCE ORDER |
| 1. Remove an asterisk of a bent shaft |
|
|
2. Drill two holes in an epiploon, screw in in them screws and take an epiploon. |
| 3. Carefully clean an epiploon groove. |
|
4. Oil a new epiploon and hammer it on the place. |
|
BACK EPIPLOON OF THE BENT SHAFT
| PERFORMANCE ORDER |
| 1. Remove a flywheel. |
| 2. Drill two holes in an epiploon, screw in in them screws and take an epiploon. Establish a new epiploon. |
| 3. Establish a flywheel into place. |
|
|
|
