Opel Omega

since 1993-1999 release

Repair and operation of the car


Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   - 3.1. SOHC engines of 2,0 liters
      3.1.1. Technical characteristics
      3.1.2. Check of a compression
      3.1.3. Top Dead Point (TDP) of the N1 piston
      3.1.4. Camshaft cover
      3.1.5. Pulley of a bent shaft
      3.1.6. Covers of a gas-distributing belt
      3.1.7. Gas-distributing belt
      3.1.8. Natyazhitel of a gas-distributing belt and asterisk
      3.1.9. Camshaft epiploon
      3.1.10. Casing of the camshaft and camshaft
      3.1.11. Pushers and hydraulic elevators
      3.1.12. Head of cylinders
      3.1.13. Oil pallet
      3.1.14. Oil pump
      3.1.15. Flywheel
      3.1.16. Epiploons of a bent shaft
      3.1.17. Fastenings of the engine and transmission
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   + 3.4. Partition of all petrol engines
   + 3.5. 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment


785173a6

3.1.15. Flywheel

Removal

MECHANICAL TRANSMISSION

PERFORMANCE ORDER
1. Remove the transmission and coupling.
2. Stop a flywheel and note its correct adjusting arrangement.
3. Unscrew bolts and remove a flywheel.

AUTOMATIC TRANSMISSION

PERFORMANCE ORDER
1. Remove the transmission.
2. Stop a drive plate and weaken its bolts.
3. Completely unscrew bolts and remove a drive plate.

Check

PERFORMANCE ORDER
Check a flywheel for existence of wear and damages. At detection of those address the expert.

Installation

MECHANICAL TRANSMISSION

PERFORMANCE ORDER
1. Mechanical transmission
2. Clean the joined surfaces of a flywheel and a bent shaft. Clean carvings of bolts.
3. Establish a flywheel, insert and tighten bolts till the necessary moment of an inhaling (the drawing at the left), and then in addition on a necessary corner (the drawing on the right) (see subsection 3.1.1)
4. Establish coupling and the transmission.

AUTOMATIC TRANSMISSION

PERFORMANCE ORDER
1. Clean the joined surfaces of a drive plate and a bent shaft. Clean carvings of bolts.
2. Establish a drive plate and tighten bolts.