Opel Omega + 1. Maintenance instruction + 2. Maintenance - 3. Repair of engines + 3.1. SOHC engines of 2,0 liters + 3.2. DOHC engines of 2,0 liters - 3.3. 2,5 and 3,0 liters engines 3.3.1. Technical characteristics 3.3.2. Check of a compression 3.3.3. Top Dead Point (TDP) of the N1 piston 3.3.4. Covers of camshafts 3.3.5. Pulley of a bent shaft 3.3.6. Covers of a gas-distributing belt 3.3.7. Gas-distributing belt 3.3.8. Natyazhitel of a belt, asterisks and intermediate pulleys 3.3.9. Epiploons of camshafts 3.3.10. Camshafts and pushers 3.3.11. Head of cylinders 3.3.12. Oil pallet 3.3.13. Oil pump 3.3.14. Oil heater 3.3.15. Flywheel and drive plate 3.3.16. Epiploons of a bent shaft 3.3.17. Fastenings of the engine and transmission + 3.4. Partition of all petrol engines + 3.5. 2,0 liters diesel engine + 3.6. 2,5 liters diesel six-cylinder engine + 4. Heating system and ventilation + 5. Fuel, exhaust systems + 6. System of start of the engine + 7. System of ignition + 8. Coupling + 9. Transmissions + 10. Main transfer, half shafts + 11. Brake system + 12. Suspension bracket and steering + 13. Body + 14. Body electric equipment
|
Removal
PERFORMANCE ORDER |
Mechanical transmission |
1. Remove the transmission and coupling. |
|
2. Stop a flywheel and note its correct adjusting arrangement. |
3. Unscrew bolts and remove a flywheel. |
Automatic transmission |
4. Remove the transmission. |
5. Stop a drive plate and weaken its bolts. |
6. Completely unscrew bolts and remove a drive plate. |
|
Check
Check a flywheel for existence of wear and damages. At detection of those, address the expert.
Installation
PERFORMANCE ORDER |
Mechanical transmission |
1. Clean the joined surfaces of a flywheel and a bent shaft. Clean carvings of bolts. |
2. Establish a flywheel, insert and tighten bolts. |
3. Establish coupling and the transmission. |
Automatic transmission |
4. Clean the joined surfaces of a drive plate and a bent shaft. Clean carvings of bolts. |
5. Establish a drive plate and tighten bolts. |
|
|
|