Opel Omega

since 1993-1999 release

Repair and operation of the car

Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   + 3.1. SOHC engines of 2,0 liters
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   + 3.4. Partition of all petrol engines
   - 3.5. 2,0 liters diesel engine
      3.5.1. Technical characteristics
      3.5.2. Repair operations on the engine installed in the car
      3.5.3. Check of pressure of compression 3_5_4.htm
      3.5.5. Gas distribution mechanism
      3.5.6. Cover of a head of the block of cylinders
      3.5.7. Pulley of a bent shaft
      3.5.8. Chain cover
      3.5.9. Natyazhiteli of a chain
      3.5.10. Chains and asterisks
      3.5.11. Camshafts and pushers
      3.5.12. Head of the block of cylinders
      3.5.13. Oil pallet
      3.5.14. Oil pump
      3.5.15. Oil heater
      3.5.16. Sealing rings of a bent shaft
      3.5.17. Flywheel
      3.5.18. Suspension brackets of the power unit
      + 3.5.19. Capital repairs of the 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

3.5.15. Oil heater

GENERAL INFORMATION

The oil heater is installed on a forward left part of the block of cylinders of the engine. On engines till 1998 the oil heater is placed in a casing of an oil filter, and on models since 1998 fastens bolts to a forward part of a casing of an oil filter.

Removal

PERFORMANCE ORDER

1. Lift a forward part of the car and record on supports.
Models till 1998.
2. Press hoses of supply of cooling liquid to the oil heater. Weaken collars and remove hoses from a radiator.
3. Wipe area about a casing of an oil filter, unscrew bolts and remove a casing and laying from a head of the block of cylinders.

4. Unscrew screws and uncover the oil heater (the drawing at the left) and laying a forward part of a casing of an oil filter (the drawing on the right).
	5. Unscrew bolts from a back part of a casing of an oil filter

6. Remove the oil heater (the drawing at the left) together with sealing rings (are specified by shooters in the drawing on the right).
Models since 1998.
7. Press hoses of supply of cooling liquid to the oil heater. Release collars and remove hoses from the oil heater.
8. Wipe area about the oil heater, unscrew bolts and remove the oil heater and laying from a casing of an oil filter.

Installation

PERFORMANCE ORDER

Installation is made in the sequence, the return to removal. At the same time it is necessary to establish new laying and sealing rings.