Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
+ 3.1. SOHC engines of 2,0 liters
+ 3.2. DOHC engines of 2,0 liters
+ 3.3. 2,5 and 3,0 liters engines
+ 3.4. Partition of all petrol engines
- 3.5. 2,0 liters diesel engine
3.5.1. Technical characteristics
3.5.2. Repair operations on the engine installed in the car
3.5.3. Check of pressure of compression 3_5_4.htm
3.5.5. Gas distribution mechanism
3.5.6. Cover of a head of the block of cylinders
3.5.7. Pulley of a bent shaft
3.5.8. Chain cover
3.5.9. Natyazhiteli of a chain
3.5.10. Chains and asterisks
3.5.11. Camshafts and pushers
3.5.12. Head of the block of cylinders
3.5.13. Oil pallet
3.5.14. Oil pump
3.5.15. Oil heater
3.5.16. Sealing rings of a bent shaft
3.5.17. Flywheel
3.5.18. Suspension brackets of the power unit
+ 3.5.19. Capital repairs of the 2,0 liters diesel engine
+ 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
RIGHT SEALING RING OF THE BENT SHAFT
Replacement
| PERFORMANCE ORDER |
| 1. Remove a pulley of a bent shaft. |
|
2. Using a screw-driver edge as the lever, take a sealing ring from a chain cover. |
| 3. Clear a nest of a sealing ring and the condensed surface of a bent shaft. |
|
4. Grease working edges of a new sealing ring with pure engine oil and, using a tubular mandrel, establish a sealing ring. |
| 5. Remove all traces of oil and establish a pulley of a bent shaft. |
|
LEFT SEALING RING OF THE BENT SHAFT
Replacement
| PERFORMANCE ORDER |
| 1. Remove a flywheel. |
|
2. Drill two small openings in an end face of a sealing ring, screw in two self-cutting screws and flat-nose pliers for heads of screws extend a sealing ring from a nest. |
| 3. Clear a nest of a sealing ring and the condensed surface of a bent shaft. |
|
4. Grease working edges of a new sealing ring with pure engine oil and, using a tubular mandrel, establish a sealing ring into place. Establish a flywheel. |
|
|
|
