Opel Omega

since 1993-1999 release

Repair and operation of the car



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   + 3.1. SOHC engines of 2,0 liters
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   + 3.4. Partition of all petrol engines
   - 3.5. 2,0 liters diesel engine
      3.5.1. Technical characteristics
      3.5.2. Repair operations on the engine installed in the car
      3.5.3. Check of pressure of compression 3_5_4.htm
      3.5.5. Gas distribution mechanism
      3.5.6. Cover of a head of the block of cylinders
      3.5.7. Pulley of a bent shaft
      3.5.8. Chain cover
      3.5.9. Natyazhiteli of a chain
      3.5.10. Chains and asterisks
      3.5.11. Camshafts and pushers
      3.5.12. Head of the block of cylinders
      3.5.13. Oil pallet
      3.5.14. Oil pump
      3.5.15. Oil heater
      3.5.16. Sealing rings of a bent shaft
      3.5.17. Flywheel
      3.5.18. Suspension brackets of the power unit
      + 3.5.19. Capital repairs of the 2,0 liters diesel engine
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment


785173a6

3.5.3. Check of pressure of compression

GENERAL INFORMATION

Check of a condition of the engine can be made by measurement of pressure of compression in cylinders. If to make this check regularly, then it is possible to learn the beginning of wear of the engine in advance, without waiting for the moment when wear is shown in low overall performance of the engine.

PERFORMANCE ORDER
1. Using компрессометр with an adapter, check compression pressure in engine cylinders.
2. Before check of pressure of compression check that the accumulator was charged also in good shape. The air filter has to be pure, and the engine has to be heated-up up to the normal working temperature. Before check unscrew glow plugs. For prevention of start of the engine when conducting check disconnect the electric socket from the control unit of the fuel pump of high pressure.
3. Establish an adapter with kompressometry in an opening for installation of candles of an incandescence.
4. Turn the engine a starter. After a provorachivaniye of a bent shaft by 1 or 2 turns pressure of compression has to increase to a maximum and then be stabilized. Make record of most received result. Similarly check other cylinders.
5. Compression pressure in all cylinders should not differ more, than on two units. Pay attention that the size of compression has to increase quickly on the serviceable engine. The low pressure of compression on the first turn of a bent shaft accompanied with gradual increase in pressure on the subsequent turns indicates wear of piston rings. The low size of pressure on the first turn of a bent shaft which slightly increases further indicates a thinness of a prileganiye of valves, the punched laying of a head of the block of cylinders or existence of cracks in a head of the block of cylinders.
6. After conducting check of pressure of compression connect the electric socket to the control unit of the fuel pump and establish glow plugs.