Opel Omega

since 1993-1999 release

Repair and operation of the car


Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   + 3.1. SOHC engines of 2,0 liters
   + 3.2. DOHC engines of 2,0 liters
   + 3.3. 2,5 and 3,0 liters engines
   + 3.4. Partition of all petrol engines
   - 3.5. 2,0 liters diesel engine
      3.5.1. Technical characteristics
      3.5.2. Repair operations on the engine installed in the car
      3.5.3. Check of pressure of compression 3_5_4.htm
      3.5.5. Gas distribution mechanism
      3.5.6. Cover of a head of the block of cylinders
      3.5.7. Pulley of a bent shaft
      3.5.8. Chain cover
      3.5.9. Natyazhiteli of a chain
      3.5.10. Chains and asterisks
      3.5.11. Camshafts and pushers
      3.5.12. Head of the block of cylinders
      3.5.13. Oil pallet
      3.5.14. Oil pump
      3.5.15. Oil heater
      3.5.16. Sealing rings of a bent shaft
      3.5.17. Flywheel
      3.5.18. Suspension brackets of the power unit
      - 3.5.19. Capital repairs of the 2,0 liters diesel engine
         3.5.19.1. Technical characteristics
         3.5.19.2. Head of the block of cylinders
         3.5.19.3. Pistons and rods
         3.5.19.4. Bent shaft
         3.5.19.5. Block of cylinders of the engine
         3.5.19.6. Radical bearings and bearings of rods
         3.5.19.7. Engine balance of assembly at capital repairs
         3.5.19.8. Piston rings
         3.5.19.9. Working gaps of radical bearings
         3.5.19.10. Working gaps of conrod bearings
         3.5.19.11. Start of the engine after capital repairs
   + 3.6. 2,5 liters diesel six-cylinder engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. System of ignition
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, half shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment


785173a6

3.5.19.7. Engine balance of assembly at capital repairs
GENERAL INFORMATION

Assembly of the engine has to be executed in the following order:

  – bent shaft;
  – pistons and rods;
  – chains and asterisks of the mechanism of gas distribution;
  – oil pump;
  – oil pallet;
  – flywheel;
  – head of the block of cylinders;
  – inlet and final collectors;
  – hinged knots.